diff --git a/1209/4F45/index.md b/1209/4F45/index.md
new file mode 100644
index 00000000..e213ea42
--- /dev/null
+++ b/1209/4F45/index.md
@@ -0,0 +1,9 @@
+---
+layout: pid
+title: OEP probe (OpenEmbeddedProbe firmware)
+owner: Open-Embedded-Probe
+license: MIT
+site: https://github.com/Open-Embedded-Probe/oep-probe-arduino
+source: https://github.com/Open-Embedded-Probe/oep-probe-arduino
+---
+USB debug probe and test fixture firmware built from the OpenEmbeddedProbe Arduino library (in the Arduino Library Manager as OpenEmbeddedProbe), running on ESP32-P4, RP2350 and RP2040 boards. It speaks the Open Embedded Probe protocol (https://github.com/Open-Embedded-Probe/oep-spec) over USB vendor bulk, HID and CDC: debug wires for WCH CH32 (RVSWD / SWIO) and ARM (SWD), a target console, GPIO / UART fixtures and logic capture. The conditions for using this PID are in https://github.com/Open-Embedded-Probe/oep-probe-arduino/blob/main/PID-USE.md
diff --git a/org/Open-Embedded-Probe/index.md b/org/Open-Embedded-Probe/index.md
new file mode 100644
index 00000000..f0deb664
--- /dev/null
+++ b/org/Open-Embedded-Probe/index.md
@@ -0,0 +1,6 @@
+---
+layout: org
+title: Open Embedded Probe
+site: https://github.com/Open-Embedded-Probe
+---
+Open Embedded Probe (OEP) is an open protocol, and its open-source implementations, for probes used in embedded development: one small board that is at once a debugger, a console to the target and a test fixture, driven by any host through the same protocol.